Popular Posts
-
The application of an emitter resistor (R4) provides improved stability but it also gives reduced gain. When needed, we can restore the g... -
The TCP/IP protocol suite is used in internet was developed prior to OSI model. Therefore the layers used in Transmission control protocol/I...
-
1428. The Miller oscillator is the crystal equivalent of a Hartley oscillator in which no mutual inductance exists between the plate-to c...
-
The BCD counters are not binary counters. The Binary counters divide by 2 at each stage, and their outputs run from 0 to (2 n - 1), wher...
-
The Magneto-motive force (mmf) is the cause due to the presence of the a magnetic flux in a magnetic circuit, mmf , F m = NI amperes whe... -
It is normal when the temperature of a material increases, the resistance increases in the most of conductors, insulators decrease in resis... -
Every atom is composed of protons, neutrons and electrons . The protons bears positive electrical charge, there is no electrical charge on t... -
A normally used technique for the purpose of eliminating crossover distortion is by way of biasing the transistors so that they are on the ... -
The two-port network has a pair of input terminals, shown as PQ in Figure below, & a pair of output terminals, shown as RS in the dia... -
An ammeter , which is used for measuring current, offers a low level resistance (ideally 0) & must be connected in series with the ci...
0 comments:
Post a Comment